Commissioning; Function - Franke PRTR0009 Notice De Montage Et De Mise En Service

11. Commissioning

11.1 Open the water supply.
Caution!
First fill the hot water heater tank.
11.2 Insert the power plug in the socket.
☞
Observe the operating instructions for the hot water heater.

12. Function

12.1 Allow your hand to approach the sensor.
• Water flows.
12.2 Remove your hand from the sensor.
• Water flow stops automatically after a set flow duration.
☞
The range of the sensor and the flow duration can be adjusted with the optional
remote control (FAR Order No. 2000101087).
☞
Important!
Reflecting surfaces can influence the sensor. There is a risk of having permanent
reflections (see
"Auto-flush" function
Caution!
When the "Auto flush" function is used, the flow of water must be ensured.
• The "Auto-flush" function ensures that forced flushing takes place to exchange the
water in the tap lines after 24 or 72 hours of non-use.
• The "Auto-flush" function can only be switched on with the optional remote control
(FAR-Order-No. 2000101087).
• This function is switched off at the factory.
Chapter 13. for adjusting the sensor range).
info@hygiene-shop.eu - www.hygiene-shop.eu
7