Philips AVENT SCF870 Mode D'emploi page 16

EngliSh
16
Problem
The appliance
continues to give
off an unpleasant
smell after I used it
a few times.
The appliance
makes a lot of
noise, produces an
unpleasant smell,
feels hot to the
touch, emits
smoke, etc.
The lid of the jar
leaks.
There are white
spots on the illing
opening and/or on
the jar, sieve and
lid.
The appliance
produces a lot of
noise while it is
blending.
The water in the
water tank has an
unusual colour
when you pour it
out of the water
tank or when it
enters the jar
during steaming,
or the water in
the water tank has
an unpleasant
smell.
Possible cause
You put too much
food in the jar or
you let the appliance
blend too long.
There is too much
food in the jar.
You let the appliance
operate too long
without interruption.
You have not
assembled the lid on
the jar properly.
There is too much
food in the jar.
Scale has built up on
these parts.
The sieve is not
attached to the lid of
the jar.
Food particles have
entered the water
tank during use.
Solution
Process smaller quantities and do not let the
appliance blend for more than 30 seconds at a
time.
Switch off the appliance and process a smaller
quantity.
Do not let the appliance blend for more than 30
seconds at a time.
Assemble the lid on the jar properly. See chapter
'Using the appliance'.
Switch off the appliance and process a smaller
quantity.
This is normal. Remove the scale periodically. See
chapter 'Cleaning and maintenance', section
'Descaling'.
Make sure that the sieve is attached to the lid of
the jar.
Clean the water tank according to the instructions
in chapter 'Cleaning and maintenance, section
'Descaling the water tank'. Use the appliance strictly
according to the instructions. Make sure you do not
overill the water tank with water (max 200ml) and
that you do not overill the jar with food (do not ill
the jar beyond the top edge of the green blade
unit). Do not steam the same ingredients for more
than 20 minutes and do not put water for steaming
directly in the jar. Also make sure that the valve is
ixed in the lid.