Product Description; Technical Specifications; First Use And Charging; Charging Process - Lenz rcB 1200 Mode D'emploi

OPERATING INSTRUCTIONS / ENGLISH

PRODUCT DESCRIPTION

lithium pack rcB 1200 / lithium pack rcB 1800
Snap fasteners to establish the connection to the charger and the heatable textile (Fig. 1.1)
￭
Heat setting display 1 / 2 / 3 (Fig. 1.2)
￭
Control button (Fig. 1.3)
￭
Contact protector (Fig. 1.4)
￭
Charger
Power supply (Fig. 2.1)
￭
Charge indicator (Fig. 2.2)
￭
Charger plug (Fig. 2.3)
￭

TECHNICAL SPECIFICATIONS

Global USB power supply unit Input: 100 V - 240 VAC
(with exchangeable plug) (50/60 Hz), max. 150 mA
lithium pack rcB 1200
lithium pack rcB 1800

FIRST USE AND CHARGING

Important note:
Charge the lithium packs prior to their first use!

Charging process

1. Connect the charging cable with the USB power supply unit and plug the USB power
supply unit into a socket. The charge indicator (Fig. 2.2) will light up green.
2. Remove the contact protector (Fig. 1.4) and connect both lithium packs to the charging plugs
of the charging cable (Fig. 2.4). Please refer to the diagram on the charging plugs for correct
orientation. The lithium packs can be charged in any operating mode.
3. The charging process starts after one-time operation of the control button (Fig. 1.3.).
4. The charge indicator (Fig. 2.2) will light up red during the charging process.
Output: 5V / 1A DC
Output: 3,7 V / 2400 mAh
Output: 3,7 V / 3600 mAh
– 22 –
5. Once the lithium packs are fully charged, the charging process automatically ends and
the charge indicator (Fig. 2.2) changes back to green.
6. The charging status can be monitored with the LEDs on the lithium pack, which light up
successively as the charge increases, or using the Lenz heat app* which offers convenient
control.
7. After the end of the charging process, please disconnect both lithium packs from the
charging plugs.
Important note:
Because naturally occurring minimal differences due to production can occur,
￭
the charge indicator in the Lenz heat app* only serves as a general indicator.
If you are using a USB power unit other than the USB power unit included by the
￭
manufacturer, it must meet the mentioned technical specifications and comply
with all applicable safety standards and guidelines.
Charge the product after every use.
￭
This helps extend the life of the lithium packs and ensures that the product is
￭
ready for use at any time.
The battery consists of lithium ion cells and can be charged in any state.
￭
For this reason, the battery does not need to be fully discharged before charging.
￭
The full charging capacity of the product can only be conserved if the product
￭
is disconnected from the charging plugs after the end of the charging process.
lithium pack rcB 1200
Charging time
lithium pack rcB 1800

SAFETY FUNCTIONS

Short circuit protection: In the event of a short circuit at the contact or the heating element,
￭
the integrated electronics automatically turn the product off. After removing the short circuit,
please briefly connect the lithium packs to the charging plugs. Next, press the control button
once and the product is ready again.
Protection against overcharging and exhaustive discharge: The product is protected
￭
against overcharging and exhaustive discharge with the integrated electronics system.
5 – 7 h
7 – 9 h
– 23 –