Silhouette DIM3225BLSST SELECT Guide D'utilisation Et Soins De Propriètaire page 9

Ice Maker Performance Mode Instructions (cont)
Performance
Mode
Manual drainage Manually drain the
water from the ice
system mode
box.
(If your operating using
the "Manual drainage
system mode",ice wate r
will restrict drain water
from flowing out. )
CONTROLS OF THE ICE MAKER
The Ice Maker should be placed where the ambient temperature is between 10-32°C (50-90°F). If the ambient
temperature is above or below this range, the performance of the unit may be affected.
OPERATING INSTRUCTIONS
Instructions Suitable situation
There is no drain hole
in the room
Operation instruction
Ref: Fig.A & Fig.B & Fig.C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front)(4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
1. Please insure the screw nut and switch are in the
above condition to avoid water leakage
2. Periodically check the Ice box (1), water level ruler(5).
If the water level exceeds the ruler water level,please
drain off the unnecessary water.
3. When draining off the water, you can remove the Ice
box(1), screw nut(front)(3) and seal washer(front)(4)
use the holder to take out the unnecessary water, then
tighten the above screw and seal washer.
7
Condition
lock
lock
lock
lock
OFF