Silhouette DIM3225BLSST SELECT Guide D'utilisation Et Soins De Propriètaire page 10

CONTROLS OF THE ICE MAKER
Control
1
"Water tank is full."
a> Please unscrew the drain cap (12) located on the back of the unit and let out the water. (Refer Page5.Fig.B)
b> After draining out all the water from the outside water tank, reconnect unit to power and it will continue to run normally.
c> If "Drain pump mode" is chosen, please confirm the "Pumped water outlet switch" is in the "ON" position. If it is in the
correct position, but still get a WARNING ALARM after you power off the unit, please contact a service center.
d> If "Manual drainage system mode" is chosen, the outside water tank will be full with water within one or two weeks
according to different ambient tempeartures, please drain out the water.
2
"Ice maker low on water"
a> Please check if outside water supply is functioning normally. Please see "Checking the water supply" box above.
b> The icemaker will remove faults automatically within 30 minutes and work normally when outside water pipe is
functioning.
c> Please press " " button and turn on the unit again if icemaker does not function normally after 30 minutes;
d> If the icemaker still shows a WARNING ALARM after the above process is repeated, please contact the service center.
3
"Sensor breakdown." Please contact our authorized service center to maintain.
OPERATING INSTRUCTIONS
Type Condition
Button
Button
Button
Button
Indicator Light
FLASHING
Indicator Light
FLASHING
Indicator Light
FLASHING
Indicator Light
FLASHING
Indicator Light
Flashing at the same
Flashing at the same
Indicator Light
Function Explanation
To turn the Ice Maker on/off
Press
(press and hold this button
for approximately 3 seconds)
Press Small amount of ice
Press Medium amount of ice
Press Large amount of ice
Small amount of ice is
ON
selected.
Water tank is full.
Medium amount of ice is
ON
selected.
Ice box is full of ice.
Large amount of ice is
ON
selected.
Ice box is full of ice.
Compressor works
ON
OFF Compressor stopped working
Stand by condition
Ice maker low on water
time
Sensor breakdown
time
8
CHECKING THE WATER
SUPPLY
1. Turn off water supply.
2. Disconnect line from the ice
maker.
3. Position water supply line in a
bucket.
4. Turn on water and make sure
water fills in the bucket.
5. Before reconnecting the
water supply line to ice
maker, make sure the water
is turned off, then reconnect
the water supply line to the
ice maker.
* If unsure please contact
your local plumber.
1
2
3