Original accessories/auxiliary
equipment
■
Use only the additional equipment and ac-
cessories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instructions
can lead to a risk of injury.
Information on saw blades
You can use any saw blade that has a suitable
mount – ½" (12.7 mm) universal shaft. Saw blades
are available from retail stores in various lengths
and optimised for a variety of purposes.
NOTE
►
TPI = teeth per inch = the number of teeth per
2.54 cm
Before use
Charging the battery pack
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed battery
charger
.
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack
battery charger
.
♦
Insert the power plug into the socket. The control
LED
lights up red.
♦
The green control LED
charging process is complete and the battery
pack is ready for use.
♦
Push the battery pack
ance.
■
Never recharge a battery pack
mediately after rapid charging. This could over-
charge the battery pack
lifespan of the battery and charger.
■
6
│
GB │ IE
from or connect
when the
to the high-speed
indicates that the
back into the appli-
again im-
, thus reducing the
♦
You should always switch the high-speed char-
ger
off for at least 15 minutes between suc-
cessive charging processes. Also disconnect the
power plug from the mains power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Click the battery pack
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the test button
level of the battery (see Fig. A).
The status/remaining charge will be shown on
the battery charge level display
♦
RED / ORANGE / GREEN = maximum
charge/performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
into the handle
.
and remove the
to check the charge
as follows:
FAAS 12 A1