English - Krups Nespresso 893 Mode D'emploi

English

Description
a Removable water tank
b Indicator light (red)
c On/Off switch
d Capsule holder
e Grid
f Drip tray
g Hot plate for cups
h Temperature indicator light (yellow)
i Function selector
j Hot water/steam nozzle
k Cappuccino accessory
l Cord storage
m Cleaning needle
n Special hexagonal key (for dismantling
the capsule cage)
o Selector for hot water/ steam
Safety recommendations
• Before using your espresso maker for the
first time, please read these instructions
carefully. Only use an earthed plug to
connect the appliance. Check that the
voltage indicated on the information plate
on the appliance does in fact match that of
your electrical wiring system.
Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS
1363 type, and therefore do not accept the
plug connected to this appliance, cut off the
plug.
When cut off, this plug is a shock hazard if
inserted into a socket outlet and must
therefore be disposed of safely.
If the fuse cover is detachable, never use the
14
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the
instructions in paragraph "Fitting a plug".
With alternative plugs a 15 amp fuse must be
fitted either in the plug or adaptor or at the
main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW
BLUE
BROWN
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter 'E' or by the
earth symbol or coloured green or green
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter 'N' or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC).
• Do not place your espresso maker on a hot
surface (electrical hotplate, for example) or
close to a flame.
• Do not remove the capsule holder
containing the coffee while water is running
through, as the appliance is under pressure
at this time.
• Do not use the appliance when the drip tray
and the grid are not in place.
• The plug must be removed if a problem
occurs while the coffee is running through
or before cleaning your appliance.
• Do not unplug the appliance by pulling on
the cord and do not place the cord on a
sharp edge or the corner of an item of
furniture.
: EARTH
: NEUTRAL
: LIVE