How To Order Spare Parts; How To Dispose Of The Packing; How To Dispose Of The Unit - Zanotti SP O Notice De Mode D'emploi Et D'entretien

Room sensor
Evaporator sensor
High pressure
Voltage monitor

13 HOW TO ORDER SPARE PARTS

When ordering spare parts make reference to the number written on the unit plate.
WARNING
Worn parts should be replaced only by qualified personnel or by the manufacturer.

14 HOW TO DISPOSE OF THE PACKING

Wooden, plastic, polystyrene packing shall be disposed of according to the regulations in force in the

15 HOW TO DISPOSE OF THE UNIT

Do not discharge scrapped components in the environment. They should be disposed of by companies
WARNING
Do not discharge the refrigerant in the atmosphere. It should be disposed of by
companies dealing with special waste collection and recovery.
Steady (E0).
(E1) alternating with cold
room temperature
(HH) alternating with room
temperature; LED (4) lights
up each time the high
pressure switch is tripped.
If more than 10 trips occur
in one hour, then (PP)
alternating with cold room
temperature is displayed
and alarm relay is activated
together with LED (4).
In this situation all
functions are interrupted.
(AM) alternating with cold
room temperature. The
voltage monitor is an
electronic device which
checks the supply voltage
of the unit when voltage
variations exceed +/-12%.
The unit stops for about 6
minutes and restarts
automatically if voltage is
within the prescribed limits.
Warning: on first starting
the monitor carries out a
counting phase of 7
minutes, during which the
unit should be left
connected but in OFF
condition.
country where the unit is used.
dealing with special waste collection and recovery, according to the regulations in force
in the country where the unit is used.
Sensor not connected
Sensor not connected
Faulty operation of
condenser fan.
Dirty condenser.
Wrong supply voltage
Replace sensor
Replace sensor
Switch off the refrigerating
unit, wait a few seconds
and switch on again.
28