Checks, Regulations And Adjustments; Starting - Zanotti SP O Notice De Mode D'emploi Et D'entretien

9

Checks, regulations and adjustments

9.1

Starting

ATTENTION
Medium temperature range :
Low temperature range :
Setting room temperature:
6. "SET" key : when pressed for 2 seconds it lights up and allows room temperature
to be set. During programming it is used to pass from a submenu to an
upper one.
7. "DOWN/ROOM LIGHT" key: in programming mode or when setting room
temperature
switch on/off the cold room light.
8. "SB.M./UP" key: in programming mode it is used to increase the values displayed. If
pressed for more than 5 seconds it enables manual defrost to be carried out.
9. "ON/OFF" key: when pressed for 2 seconds it turns the unit on or off.
10. "Enter" key: it gives access to programming menu and submenus. Access to the
programming mode requires the installator's assistance and should be effected only if
necessary.
Before turning the unit on, check that:
- locking screws are tight
- electrical connections have been carried out correctly.
In the event that the unit has been opened:
- no tools were left inside
- assembly is correct
- there are no gas leaks
- front cover is secured correctly
Before starting the unit act as follows:
Connect the unit to the mains. The display is turned on and shows OFF.
-
If the unit has a preheating cycle, leave it in this condition for at least 3 hours.
-
If the unit has a voltage monitor, leave it in this condition for at least 7 minutes to
-
have the counting phase carried out
Set the required cold room temperature.
-
- Press ON/OFF key to switch the unit on.
• Connect the unit to the mains. OFF is displayed.
• Press SET for three seconds. The green led lights up and the previously set
temperature is displayed.
• To change this value press following keys:
• UP to increase temperature
it is used to reduce the value displayed; otherwise it is used to
+10 -5°C
-15 -25°C
25