Air Conditioner Use; Starting Your Air Conditioner - Haier ESA415J Guide D'utilisation Et D'entretien

Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
MODE SPEED TIMER
FAN HIGH
COOL MED
ENERGY LOW
SAVER
DEHUM
1. Remove the clear plastic film from the control panel.
2. Press POWER to turn on the air conditioner. The Power
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display
will show "88" for 3 seconds. After the air conditioner is turned
on for the first time, the display will show the current room
temperature and the fan is set to Low speed. When the air
conditioner is turned on at all other times, the display will show
the previous settings for 5 seconds, and then show the current
room temperature.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light glow for the
desired setting.
2. Choose Fan, Cool, Energy Saver or Dehum.
■
Fan—Only the fan runs. Press SPEED to select High, Med
or Low fan speed. The display shows the current room
temperature.
■
Cool—Cools the room. Press SPEED to select High, Med
or Low fan speed. Press the TEMP/TIME up or down
arrow button to adjust the temperature.

AIR CONDITIONER USE

Starting Your Air Conditioner

TEMP / TIME
ON
OFF
POWER
POWER
■
Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evapora-
tor coil will freeze up, and the air conditioner will not operate
properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
■
Energy Saver—Fan runs only when cooling is needed. Press
SPEED to select High, Med or Low fan speed.
Because the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as often.
■
Dehum—Dries the room. The air conditioner automatically
selects the temperature. Fan runs on Low speed only.
NOTE: Dehum mode should not be used to cool the room.
MODE
NOTE: After 5 seconds, display will show the current room
temperature.
Fan Speed
NOTE: In Dehum mode, the Speed button will not operate.
1. Press FAN SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med or Low.
■ High—for maximum cooling
■ Med—for normal cooling
■ Low—for minimum cooling
SPEED
NOTE: After 5 seconds, the display will show the current room
temperature.
FAN
COOL
ENERGY
SAVER
DEHUM
HIGH
MED
LOW
9