Yamaha YDS-12 Mode D'emploi page 11

■ Connecting the dock
1. Set the Mode switch to A (default).
If you're using a Yamaha dock-
compatible audio component that's
listed in the Appendix at the end of this
manual, set the Mode switch to B.
Mode switch
2. Connect one of the plugs of the dock
cable to the dock cable terminal of
this unit firmly.
See "Appendix" at the
end of this manual.
Default
Connect the plug
with the side with
the release button
facing upward.
3. Make sure the power of the dock-
compatible audio component is
turned off.
Note
Connecting the dock connection cable while
the dock-compatible audio component's
power is on could result in damage.
4. Connect the other plug of the dock
cable to the DOCK jack of the dock-
compatible audio component.
DOCK
Note
Be sure to connect the plugs of the dock
cable firmly to both the dock cable terminal
of this unit and the DOCK jack of the dock-
compatible audio component. When the
connection is loose, this unit may output
some unwanted noise.
3
En