Publicité
Les langues disponibles
Les langues disponibles
4. Ensure that the air vents are always unobstructed and clean. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
Keep in mind that there are buried objects hidden in every
!
household! Ensure that there are no gas, water or power lines
hidden in the working area that may be hit before operation –
danger of electrical shock and serious injury to people and
property damage! Use a suitable detector to trace such objects
WARNING
in advance!
b. Screw driving
1. Pre-drill the holes with a smaller screw.
2. Hold the product perpendicular to the screw to be fastened. Holding it at an
angle may cause slipping or jamming of the driver bit.
3. Place the tip of the driver bit directly on the screw first and then switch the
product on.
4. Only apply as much pressure as necessary to keep the screw in place and
the driver bit in contact with the screw head. Too much pressure will cause
damage to the screw head and driver bit; too little pressure will cause the
driver bit to slide away.
5. Remove blocked and stuck screws by changing the rotation direction.
78 | 79
GB
Publicité
