Ayce 5611 Traduction De La Notice Originale page 76

INDICATOR LIGHT
The indicator light on the product shows the charging status
Light color
Red
Green
Driver bits (Fig. 2)
There is a bit magazine in the product which holds 12 driver bits. Different driver bits
can be used with this product depending on the screw head.
To install the driver bits into the bit magazine:
1. Pull the loading cover as far back as possible.
2. Insert the bit into the socket.
3. Push the loading cover forward, and then the bit is installed. You can follow
the above mentioned instructions to install other bits.
Fig. 2
To replace the bit, remove it from the tool socket and insert a new one.
NOTE: Use only short standard screwdriver bits (25mm). Longer screwdriver bits
cannot be loaded into the bit magazine. If the bits in bit magazine are damaged, you
can remove and replace them with new bits one by one following the above steps.
Status
Charging, charger connected to power supply
Charging finish