Dometic PCD5501 Manuel D'utilisation page 11

Dometic Interact
– The status indicator shows the state of the
generator, as described in the following table:
Number Status
0 Stopped
1 Pre-Heat
2 Cranking
3 Running
4 Priming
5 Fault
6 Engine Run Only
7 Test Mode
8 Voltage-Adjust-Mode This status is unused.
9 Fault-Bypass-Mode
10 Configuration-Mode This status is unused.
For a complete list of generator statuses, refer to
I
the RV-C Specifications PDF.
– The START and STOP buttons control the output of
the generator. Tap the START button to start the
generator. The status changes to Cranking, and then
to Running. A pop-up message should also appear.
10 Ventilation Alert
• AGS: The Automatic Generator Start (AGS) indicator
shows the status of the auto generator: ON, OFF, or
disabled due to Quiet Time or External Activity. There
is also a CLEAR AGS button; when external activity is
detected, tap this button to override the external
activity demand and turn the AGS on.
External activity is a mechanism used to disable the
AGS if the generator is manually stopped or started.
This is a safety feature implemented so that if you
manually stop the generator, the AGS system does not
attempt to start it up again.
EN
Description
The generator is stopped.
The generator is
preheating. This is done
prior to the cranking cycle.
The generator is starting.
The generator is running.
The generator is
advancing fuel.
There is a fault.
The generator is running,
but not producing AC
power.
This status is unused.
This status is unused.
The Power screen also has a settings icon that you can tap
to reach the Advanced Inverter Settings screen.
11 Advanced Inverter Settings Screens
Operation
11