Technical Specifications; Battery Charging Instructions - Sunoptic Technologies SSL-3736 Mode D'emploi

3.

TECHNICAL SPECIFICATIONS

Input
Output
Operating Temperature
Storage Temperature
Humidity
Dimension (without power supply)
Weight (without power supply)
Regulatory Approvals
Water Resistant
4.

BATTERY CHARGING INSTRUCTIONS

Place the charger on a stable surface. Plug the output connector of the external AC/DC power
supply into the DC input located on the rear of the charging station. Then plug the external
AC/DC power supply into an AC outlet.
The charge process will start after inserting a battery pack into the slot after a battery recognition
and initialization. Leave the battery in the slot until the indicator light turns green. The battery is
fully charged and is ready for use. See Table 1 for a legend of the LED indicator. Each charger
comes with the manufacturer instructions for use. The further details are available there.
LED Indicator
One time Red/Orange/Green
Red/Green blinking
Orange blinking
Orange light
Green light
Red blinking
Red light
LIT-233 Sunoptic Technologies
Rev. B
Item
MINI: 19 - 26V
UNIVERSAL: 19 - 26V
17.4V
32⁰F to 104⁰F (0⁰C to 40⁰C)
14⁰F to 158⁰F (-10⁰C to 70⁰C)
5% to 95% r.H., non-condensing
UNIVERSAL: (LxWxH) 151 x 90 x 43 mm
MINI: (LxWxH) 120 x 64 x 43 mm
UNIVERSAL: 198g
MINI: 110g
UL listed and CE
Not Protected Equipment, IPX0
Self test; Charger is ready for use
The battery was not recognized as a Smart Battery. Either a
conventional battery is inserted or an extremely discharged
Smart Battery. If it is a Smart Battery, it will be reactivated within
15 minutes. If this is not the case, the LED will light red – see
below.
The battery is currently being calibrated
The inserted battery is the correct type and is currently being
charged.
The battery is fully charged and can be removed for use.
The battery is too hot or too cold to be charged without damage.
If the battery is too cold, it will be charged as soon as it has
warmed up sufficiently. If the battery is too hot, it should be
removed to cool down.
Either:
• The battery is badly damaged and must be replaced, or
• It is a conventional battery which cannot be recharged.
Table 1. LED Indicator Legend
®
Page 4 of 33
Specification
2.8A max
4.8A max
Charging Condition
3.4A max
(English)