Cleaning Instructions; Disposal/Recycle; Troubleshooting; Limited Warranty - Sunoptic Technologies SSL-3736 Mode D'emploi

NOTE:
•
The unit will become warm during normal operation. This does not indicate a malfunction.
•
Prevent metallic objects from coming into contact with the metal parts of the DC plug of
the power supply. If this happens, a short may occur and the unit may be damaged.
•
Ensure the battery has proper orientation before insertion. Do not attempt to force a
battery into the slot as this may damage the contacts.
•
Try to recharge batteries once they are fully depleted. This will allow the charger to more
accurately calculate capacity and exact charging requirements.
5.

CLEANING INSTRUCTIONS

•
Disconnect the Charger from the power source.
•
Clean the exterior of the charger with a cloth that has been dampened (not dripping) using a
hospital disinfectant. Follow applicable hospital protocols during cleaning and dry
immediately.
6.

DISPOSAL/RECYCLE

•
In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
•
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
•
Please contact our Repair Department to issue a return authorization to return product to
manufacturer at the end of product life.
7.

TROUBLESHOOTING

SYMPTOM
Battery not
charging
Charger LED
indicator not
working
8.

LIMITED WARRANTY

Your single-bay battery charger carries a 3-years warranty from the date of shipment on workmanship
and all defects of material except batteries. Should your product prove to have such defects within
three years from the date of shipment, Sunoptic Technologies
component part without charge. Should your single-bay battery charger need servicing under this
warranty, please contact Sunoptic Technologies
should carefully pack product in a sturdy carton and ship it to the factory. Please include a note
describing the defects, your name, telephone number and a return address. Warranty does not cover
equipment subject to misuse, accidental damage, and normal wear and tear. This warranty gives you
specific legal rights and you may also have other rights that vary from state to state.
LIT-233 Sunoptic Technologies
Rev. B
POSSIBLE CAUSES/SOLUTIONS
• Ensure charger power cord is plugged in to the AC power outlet.
• Ensure DC connector is plugged into the back of the charger
• Ensure battery is properly seated in the charger bay.
• If repeated attempts to charge the battery have failed, the battery may be
faulty. Replace the battery.
• The charger may have a faulty power cord and/or power brick. Replace the
power cord and/or power brick.
• Ensure charger power cord is plugged in to the AC power outlet.
• Ensure battery is properly seated in the charger bay.
• The charger may have a faulty power cord and/or power brick. Replace the
power cord and/or power brick.
®
Page 5 of 33
®
will repair or replace the product or
®
for return authorization documentation. You
(English)