Technical Specifications; Battery Charging Instructions - Sunoptic Technologies SSL-3736-2 Manuel Opérateur

3.

TECHNICAL SPECIFICATIONS

Input
Output
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Dimension (without battery adaptor)
Weight (without battery adaptor)
Regulatory Approvals
Water Resistant
4.

BATTERY CHARGING INSTRUCTIONS

Place the charger on a stable surface. Plug the output connector of the external AC/DC
power supply into the DC input located on the rear of the charging station. Then plug the
external AC/DC power supply into an AC outlet.
If desired, route the AC/DC cable under the cable retention clip located on the rear of
the charger (see Figure 1), and press down on the clip until it clicks. To release the
cable retention clip, slide the clip laterally until it clears the hook.
LIT- 232 Sunoptic Technologies
Rev. A
Item
Figure 1. Cable Retention Clip
®
Page 4 of 35
Specification
24V 2.5A max
16.8V 3.3A max
41 ⁰ F to 95 ⁰ F (5 ⁰ C to 35 ⁰ C)
14 ⁰ F to 140 ⁰ F (-10 ⁰ C to 60 ⁰ C)
10% to 90%
5% to 95%
(LxWxH) 8.9in x 3.7in x 6.1in
1.35lbs
UL listed and CE
Not Protected Equipment, IPX0
(English)