Glow Fire Jupiter Guide D'utilisation page 10

Reset:
1. Unplug the power cord from the power outlet.
2. Set the ON / OFF switch on the CONTROL PANEL to OFF.
3. Wait 5 minutes.
4. Check the fireplace to make sure no vents are blocked or clogged. If they are, use a vac-
uum to clean the vents.
5. When the POWER switch is switched off, plug the power cord back into the socket.
6. If the problem persists, have the power outlet checked by a professional.
Remote control battery information
This remote control uses two AAA batteries (not included).
Instructions for battery installation can be found on the battery compartment of the remote
control.
Care and maintenance
ALWAYS turn off the heater and pull the power cord out of the socket before
cleaning it, changing the bulbs or moving the oven. Otherwise, there is a risk of
electric shocks, fire or injury.
Never dive in water or rinse with water. Otherwise, there is electric shock, fire
or injury.
Cleaning
Metal:
Use with a soft cloth, slightly moistened
•
• Never use brass polish or household cleaners as they damage the metal.
Glass:
• Use the glass cleaner and dry carefully with a paper towel or a lint-free cloth.
Do not use abrasives or detergents that could damage the surface
•
Plastic:
Wipe with a slightly moistened cloth and a mild soap solution and warm water.
•
• Do not use abrasives or detergents that could damage the surface.
Vents:
• Use a vacuum cleaner or duster to remove dust and dirt from the heater and vent areas.
• Clean the exterior of the stove with a slightly moistened cloth or duster.
Risk of electric shock! DO NOT OPEN the main panels! No parts that can be
serviced by the user!
10