Operating Elements; Mounting - Conrad Electronic KeyMatic KM300FG Notice D'emploi

6. Operating Elements

Programming
button
Locking
nose

7. Mounting

• Remove the upper part of the housing after having pushed
in the two lateral locking noses (see figure in chapter 6).
• Fasten the lower part of the housing by screwing down
3 mm screws via the three fastening bore holes (see
drawing next page) into a wall, for example. Use plugs, if
required.
Pay attention when drilling/tightening the screws
that gas and water pipes or power lines cannot
be damaged! Danger to life!
• If desired, the door gong can also be triggered via a "normal"
bell line. For this purpose, the two wires of the bell line are
led though the recess at the rear side of the housing and
connected to the pole terminal (see figure). Both direct and
alternating voltages can be connected (up to 16V in each
case).
28
Locking
nose