shark NV351 Guide Du Propriétaire page 17

COMPONENT
1 Dust Cup
2 Pre-Motor Foam Filter
3 Pre-Motor Felt Filter
4
Post-Motor HEPA Filter
Fig. 20
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time you vacuum
and periodically during cleaning, when the dust cup
appears full.
1
Undo the latches on the sides of the dust cup by
lifting them up and outwards to remove the dust cup
from the motor base. (Fig. 18)
2
Hold the dust cup over a trash receptacle and
press the bottom door release button. (Fig. 19)
Tap gently to empty contents. Press the door shut
again until it clicks.
3
If needed, turn the dust cup upside down over the
trash receptacle and press the top door release
button. (Fig. 20) Tap gently to remove contents.
Use a dry cloth or paper towel to remove debris
stuck to the screen filter inside the dust cup. Press
the door shut again until it clicks.
4
Replace the dust cup on top of the motor base. Hook
the two latches onto the tabs on the sides of the
dust cup and push down to lock.
MAINTENANCE SCHEDULE
Empty each time you vacuum.
Rinse and air dry every 3 months under normal use.
Rinse and air dry every 3 months under normal use.
Clean once every 2 years or as needed.
Screen
Filter
Fig. 21
CLEANING THE PRE-MOTOR FILTERS
1
Remove the dust cup.
2
Pull the 2 filters out from the top of the motor base.
(Fig. 21)
3
Rinse the filters thoroughly in lukewarm water until
the water runs clear.
DO NOT put the filter in the washing machine
or dishwasher.
NOTE: The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
4
Squeeze out excess water and let air-dry for at least
24 hours before replacing. Do not use a hair dryer or
other heating methods to dry.
5
Place the felt filter in first, then the foam filter.
6
Replace the dust cup.
www.sharkclean.com
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter
17