Usage; Switching Between Connected Hdmi Sources; Edid; Edid Settings - Marmitek Connect 642 Pro Guide Utilisateur

4. Pull the plastic strip from the remote control's battery compartment to activate the
battery and remove the protective film from the top.

5 Usage

1. Infrared receiver
2. Input selector A and B
3. Audio output selector
4. 1080p downscaler A-B
5. ARC ON/OFF

5.1 Switching between connected HDMI sources

The Connect 642 Pro™ allows you to choose which HDMI source [2] is displayed on
any of the two TVs. If you want to select another HDMI source, please use the remote
control or the "Output A / B" button on the front.
To enable the auto switch function, press and hold the 'input selector' button until the
'AUTO' light turns on. To disable this, hold the button down again until the light is
turned off.

5.2 EDID

EDID stands for Extended Display Identification Data and is used for communication
between HDMI sources and TVs or projectors to determine the supported image
resolutions and audio formats. The HDMI source requests this information from the TV
or projector and determines the best resolution or audio format. When using multiple
TVs or projectors, the best resolution and audio format that is supported by all
connected displays is determined.
This may cause problems in some situations, for example, when one of the connected
sources or TVs does not fully support EDID.
5.2.1

EDID settings

Use the EDID switch to choose the following options:
• AUTO: automatically detects the highest possible common video resolution and
audio format that is supported by both TVs. Images and audio will be displayed on
both TVs.
• COPY A: only detects the resolution and audio format of the TV that is connected
to "Output A". This prevents problems with playing, for example, 3D or UltraHD
(4k). "Output A'' is usually used to connect the highest specification TV.
• STD: Both TVs will, if supported, display a resolution of 4K@60Hz HDR with 5.1ch
audio.
Tip: apply "STD" setting for standard situations and use the downscale function for
displays that only support 1080p video resolutions.
6
1
OUTPUT A
IR 1 2 3 4 AUTO A 1
2 3
OUTPUT B
2 3 4 AUTO B A B AUDIO
© MARMITEK
4 5
A B 4K->1080p ARC ON/OFF