GUTMANN Sombra Mode D'emploi page 14

en
Operation via Switch
(Located on the Ceiling Device below the Pane)
Pressing the switch to the left: Light ON/OFF
Pressing the switch to the right: Regula-
tion of the power level
Pressing the switch to the right for 3
seconds: hood is turned off.
The filter saturation display is also reset
using this switch. To do so, press the
switch to the right until the red LED turns
off.
LED Indicators
(Located on the Ceiling Device)
Information regarding the operating con-
ditions of the hood can be read on the
device's LED indicators:
Indicators
LED 1: Indicates operational status ON/OFF
LED 1 blinking: Indicates automatic cool
down period (the hood will automatically
decrease by one power level every 5
minutes until it finally turns off)
LED 2: Power level 1 (lowest motor
speed), press button 2 on the remote
control once
LED 3: Power level 2 (middle motor speed)
Press button 2 on the remote control twice
LED 4: Power level 3 (high motor speed)
Press button 2 on the remote control
three times
LED 5: Intensive level (motor automati-
cally returns to level 3 after 3 minutes)
Press button 3 on the remote control
LED 6: Filter Saturation Indicator
The metal filter must be cleaned when
the red LED lights up (see section on
cleaning and care).
F = Grease filter saturation limit: flashes
14
after 14 days (even if no cooking takes
place during this time) or 15 fan hours.
Please clean the filter and reset the dis-
play. To do this, press and hold the
switch for approx. 10 sec. until the red
LED goes out.
LED power display
Information on the operating state of the
hood can be read from the LED display
on the appliance:
Cleaning and care
Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device. Regular cleaning
of the surface saves laborious removal
of stubborn contamination. Only use
conventional detergents or universal
cleaning agents suitable for cleaning
stainless steel/aluminium. Never use
abrasive cleaning agents or steel wool.
After cleaning the hood, treat the
stainless steel surfaces with a stainless
steel care product. Painted surfaces
should only be cleaned using a mild
detergent solution and a very soft cloth.
Only use a soft damp cloth to clean the
operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the
hood. Please clean the panel under-
neath the filter regularly to prevent the
formation of stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
(located behind the glass front)