Festool CTL SYS Notice D'utilisation D'origine page 13

6.2 Connecting electric power tools
WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-10].
6.3 Connecting the suction hose
at the extraction opening [3a]

Connect the suction hose to the elbow at the ex-
traction opening.
at the exhaust opening [3b]

Open flap at rear of dust extractor.

Connect suction hose to elbow at exhaust opening.
7 Settings
7.1 Temperature monitoring
Before reaching a critical temperature, the tem-
perature monitor switches off the dust extractor.

Switch off the dust extractor, allow to cool for
about 5 minutes, then switch on again.
 Not possible to switch on: Contact Festool cus-
tomer service workshop.
7.2 Connect with the T-Loc
The dust extractor can be closed, opened and con-
nected by turning the T-Loc:
– Close dust extractor [4a].
– Open dust extractor [4b].
– Connect dust extractor to storage box [4c].
Before lifting, always close the T-Loc at the
dust extractor or connect to the storage box
and check for secure holding.
Max. load for connection to other Systainers: 20 kg
7.3 Use/Adjust carrying strap
Max. permissible load of carrying strap: 20 kg
The carrying strap can be attached in two different
positions:
– Carrying the dust extractor: Carrying strap at
dust extractor [5a]
– Carrying storage box with dust extractor: Carry-
ing strap at storage box [5b]
Before lifting, check the carrying strap for
proper functionality and put T-loc at dust ex-
tractor into corresponding position.
Adjust the length of the carrying strap at the adjust-
ing tab [5c].
8 Working
CAUTION
Hazardous dust
Damage to the respiratory passage

Always use a filter bag!
 Two cleaning nozzles are stored in the inside of
the dust extractor [6-1].
Observe the following instructions:
– The dust extractor is a stationary system and not
suitable for pulling at the cable and hose. Use
handle [1-4].
– Static charge may occur if an anti-static suction
hose is not used. The user may suffer an electric
shock.
When extracting dust that exceeds the per-
mitted limit values, only extract from a single
machine (electric or air tool).
Observe the following when extracting dust gener-
ated by operating electric power tools:
Ensure there is adequate ventilation! Observe re-
gional regulations!
Limit values: Exhaust air max. 50% of the clear air
volume
Formula: Room volume V
Please note the following after the work:

Switch off the dust extractor and pull out the
mains plug.

Wind up the mains power cable.

Empty the dirt trap.

Place suction hose [1-3] and mains power cable
in storage box.

Clean inside and outside of dust extractor by ap-
plying vacuum and wipe.

Place the dust extractor in a dry room inacces-
sible to unauthorised users.
9 Service and maintenance
WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
CTL SYS
GB
x air renewal rate L
R W
13