Hitachi DW 15Y Mode D'emploi page 5

SPECIFICATIONS
Voltage (by areas)*
Power Input
No Load Speed
Drilling Capacity
Driving Capacity
Tapping Capacity
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Chuck Wrench ........................................................... 1
(2) No. 2 Plus Bit ............................................................ 1
(3) Case ........................................................................... 1
(4) Side Handle ............................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES – sold separately
1. Sanding Disc Set
Finishing lumber surface, sanding metal, removing
rust, removing paint coatings, and many other handy
uses.
* Sanding disc diam. ................................... 130 mm
Sanding Disc
Arbor Set
2. Woolen Bonnet
Polishing or shining surfaces of furnitures,
automobiles, etc.
NOTE
In this case, the rubber pad and arbor set for the
sanding disc set are employed in addition to the
woolen bonnet.
* Bonnet diam .............................................. 125 mm
3. Plus Driver Bit
Screw Total
Bit No.
Size Length
No. 2 3 – 5 mm 70 mm
No. 3 6 – 8 mm 70 mm
Bit No.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
400 W*
0 – 2600/min
Steel: 10 mm, Wood: 15 mm
Nuts and Bolts: 6 mm, Screws: 6 mm
Steel: 6 mm, Aluminum: 10 mm
1.6 kg
Rubber Pad
Remarks
standard accessory
for temporary driving
4. Minus Driver Bit
a
0.8 mm
1 mm
a
5. Hexagon Socket (for nuts and bolts)
Socket No. Screw Size
7 4 mm
8 5 mm
10 6 mm
T6 6 mm
13 8 mm
Socket No.
6. Hexagon Bit (for hexagon socket hd. bolts)
a Bolt Size
3 mm 4 mm
4 mm 5 mm
5 mm 6 mm
6 mm 8 mm
a
7. Square Drill Bit (for wood screw's tap hole)
English
Screw Size
4 mm
5 – 6 mm
Remarks
Self-tapping screws
for temporary driving
Remarks
for temporary driving
4