Connecting Electrical Power To The Radio Link - Dometic PERFECTVIEW VT 100DIG Instructions De Montage Et De Service

Table des Matières

Les langues disponibles

VT100DIG

NOTE

Pictures and sound are sent from the transmitter module to the receiver module. To

ensure flawless functioning, you need to check whether the wireless transmission is

stable before final installation.

To perform the installation, proceed as follows:

➤ Attach the modules temporarily to the planned installation location.

➤ Install the rear view video system if you have not already done so.

➤ Start up the rear view video system.

If the camera image transmission is stable (two or three reception bars at the top right of the

monitor), you can complete final installation of the two modules.

If faults occur (only one reception bar or a yellow warning triangle on the top right of the

monitor) turn or move the transmitter or receiver module slightly and conduct further tests.

Attaching the modules (fig. 8, page 6)

To do this, proceed as follows for each module:

➤ Hold the module at the chosen location and mark the four points for drill holes.

➤ Drill holes with a Ø of 4 mm at each of the points you just marked.

➤ Screw the module on with M5 x 20mm self-tapping screws.

Fixing the antennas (fig. 9, page 6)

NOTE

Always align the antennas in the same direction, for example, both vertically.

This improves the transmission performance.

➤ You can glue the antennae on the corresponding module.