Reading Test Results On Your; Presidium Duo Tester Ii (Pdt Ii) - PRESIDIUM Duo Tester PDT II Mode D'emploi

3. READING TEST RESULTS on your Presidium Duo
Tester II
The test results are indicated as follows:
• After pressing the probe tip on the stone for about 2
seconds, the indicator will reach its highest position,
then slowly fall to a stable position. Take the reading at
the stable position.
• The tester will provide all possible results on the
display.
• The Presidium Duo Tester II should be used only to
confirm the identity of suspected gemstone.
• An example of reading the result on the meter is given
below:
When the indicator stops at the above position, the stone
tested may be Quartz, Amethyst, Citrine, Tanzanite or
Aqua, i.e., any stones that fall within the black strip that
the indicator passes.
• Metal Alert Buzzer: If the tip of the pen comes in
contact with the metal mounting of a stone, an audible
signal is emitted.
• Relatively low readings in the dark grey zone must be
expected with very small diamonds.
• Based on the thermal test results, Presidium Duo
Tester II can help distinguish between :
19