Edge-Cleaning Bristles Replacement - Rubbermaid UL12 Instructions D'utilisation Et D'entretien

Belt and Brush Roll Replacement
5
Loop belt around motor shaft.
7
2
2
Orient brush roll endcaps. Align endcaps with slots in nozzle
base while pulling brush roll towards the nozzle opening.
Reinsert into slots.
9
Reinstall screws.
(cont.)
6
Slide belt onto pulley.
8
Align tabs on nozzle guard and pivot into position, making
sure nozzle guard tab snaps into place.
14
Edge Cleaning Bristles Replacement
1 Tool needed
Unplug before servicing.
3
Install new edge-cleaning bristles. Reinstall screws.
ENGLISH
2
Remove screws. Remove old edge-cleaning bristles.
15