Sanitas SUR 28 Mode D'emploi page 16

Cleaning items
Open the cover [1]. Place the item that is to be cleaned into the inner container [2].
1
Fill the inner container [2] with water. Do not exceed the maximum fill level indi-
2
cated by the MAX mark.
In order to achieve optimum cleaning results, you should fill the inner con-
tainer just full enough so that the item is fully immersed. If you are using the
screen insert, the cleaning power is reduced.
Close the cover [1].
3
Connect the unit to the mains socket. The LED indicator [5] is illuminated in red.
4
Press the ON/OFF button [4]. The unit starts cleaning.
5
The LED indicator [5] is now illuminated in blue.
Caution!
The water in the container heats up slightly during operation.
Replace the water after the third cleaning process and fill the container with fresh
water.
The cleaning is completed after approx. 180 seconds and the LED indicator [5] is
6
illuminated in red again.
If you are not satisfied with the results, repeat the process
(step 5).
Interrupting the cleaning
7
You can interrupt the cleaning manually at any time.
To do so, press the ON/OFF button [4].
After the cleaning
8
• Open the cover [1] and remove the items from the container [2].
Pull the mains plug out of the socket.
• Dry off the cleaned items using a clean, dry cloth and allow the items to dry
completely on the cloth if necessary.
Empty all the water unless you are going to clean any additional items.
9
16