Princess 01.338901.01.650 Mode D'emploi page 10

Instruction manual
Sensors and charging connection
• Clean the appliance with a damp cloth. Never use harsh and
abrasive cleaners, scouring pad or steel wool, which damages the
device.
• Never immerse the electrical device in water or any other liquid.
The device is not dishwasher proof.
TROUBLESHOOTING
Problem Possible reason
Robot suddenly stops Robot was picked up. Re-place the robot on
cleaning and indicator
LED stays blue.
Robot is powered on, Cliff sensor fault.
indicator LED stays
blue.
Robot does not Bumper sensor fault.
change direction
when it comes into
contact with obstacle.
During charging, LED Robot switch might
indicator flashes red not be powered on.
and robot beeps.
10
RED led stays on.
Blue LED flashes
once, Red LED
flashes once.
Blue LED flashes
once, Red LED
Solution
flashes twice
Blue LED flashes
the floor and restart
once, Red LED
the robot.
flashes triple.
Clean cliff sensor.
NOTE: If all solutions given above are not helpful, please take actions
If the solution does
below:
not work, send it back
1. Reset the robot by switching on the power button on the control
to seller for repair.
panel
2. If reset doesn't work, please send robot to seller for repairing.
Check the sensor to
see if its covered by a
foreign object
ENVIRONMENT
Switch the robot on.
This appliance should not be put into the domestic garbage at
the end of its durability, but must be offered at a central point for the
recycling of electric and electronic domestic appliances. This symbol
on the appliance, instruction manual and packaging puts your
attention to this important issue. The materials used in this appliance
can be recycled. By recycling of used domestic appliances you
Dust bin is full Empty dustbin
Or Or
Dust passage is Clean dust passage.
obstructed.
Side brush is stuck. Place the robot on a
flat service and clean
side brush.
Robot bumper is not Loosen half circle of
flexible. bumper bottom screw.
Robot wheel is stuck. Check wheels and
take out foreign
object.