THEIS SMART LEVEL HV Instructions De Service page 21

6. Mode Scan
With the scan mode a laser line in 4 different
sizes can be made. To enter the scan mode
press scan button. It starts scanning with the
smallest step. By further operating the laser
line is getting bigger.
With pressing the step-by-step buttons the
laser line can be moved in every direction.
When the buttons are pressed continuously
the movement of the laser line goes faster.
By pressing the speed button the laser is in
the rotating mode.
7. Manual Mode
It is possible to make measurements with
manual slopes. The automatic mode has to
be switched off. Press the button on/off long.
The manual mode is indicated by the red
LED.
Set the slopes with the arrow buttons X and
Y.
If the traverse path is exceeded while
aligning, this is indicated by the flashing
LED and the laser beam.
You can clear the end stops again using
the arrow keys.
Slope can be set in PLUS as well as in
MINUS.
21