Horizontal Operation - THEIS SMART LEVEL HV Instructions De Service

2. Horizontal Operation

Set up the SMART LEVEL on a solid, even
ground or screw it on tight on a tripod.
Align the tripod within the range of < 5° and
press the On/Off button to activate the in-
strument. The out of level indicator is blink-
ing.
If the tripod head was tilted more than 5° , this
will be indicated after a brief period of time by
rapid flashing of the laser beam and the out
of level indicator. Should this occur, shut off
the instrument and align the tripod more care-
fully.
As soon as the laser levelling process has
been finished, the laser beam starts rotating
and the out of level indicator expires.
3. Vertical Operation / Alignment Mode
Set up the laser level with the backside down-
ward on the tripod so that operating keyboard
points upwards.
Further steps see Pkt. 2.
For alignment the laser beam has to be adjusted with
the arrow buttons y.
19