Electrical Connection Of Your Hob - Oceanic OCEACPM2G2V Instructions De Fonctionnement Et D'installation

INSTALLATION AND PREPARATIONS FOR USE
3.5

Electrical Connection Of Your Hob

· Before proceeding with the electrical connection, verify that the current carrying capacity of
the system and the socket is adequate for the maximum power rating of the hob.
· Electrical installation of the residence and the electrical current plug in use must be earthed
and conform with safety regulations.
· If there is no dedicated hob circuit and fused switch, they must be installed by a qualified
electrician before the hob is connected.
. Fused switch must be easily accessible once the hob has been installed.
· Do not use adaptors, multiple sockets and/or extension leads.
· This appliance conforms with the requirements ofthe following EEC Directives:
1. Vitroceramic hob EEC/73/23 and 93/68, EEC/89/336 relating to radio interference,
2. EEC/89/109 relating to contact with foods.
· A circuit breaker with a contact opening of at least 3mm must be installed inside the supply
circuit.
· For the knob controlled vitroceramic hob with two heating elements, the cable must be
H05VV-F 3X1,5mm². For the knob controlled vitroceramic hob with one heating elements, the
cable must be H05VV-F 3X1,0mm². You will find the connection diagram shown on the bottom
of your appliance.
L N
Figure 15
15