Additional Information; Precautions; Troubleshooting - Sony HT-SL5A Mode D'emploi

Additional Information

Precautions

On safety
Should any solid object or liquid fall into the cabinet,
unplug the amplifier and have it checked by qualified
personnel before operating it any further.
On power sources
• Before operating the unit, check that the operating
voltage is identical with your local power supply.
The operating voltage is indicated on the nameplate
at the rear of the amplifier.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the amplifier itself has been turned
off.
• If you are not going to use the amplifier for a long
time, be sure to disconnect the amplifier from the
wall outlet. To disconnect the AC power cord,
grasp the plug itself; never pull the cord.
• AC power cord must be changed only at the
qualified service shop.
On heat buildup
• Although the unit heats up during operation, this is
not a malfunction. If you continuously use this unit
at a large volume, the cabinet temperature of the
top, side and bottom rises considerably. To avoid
burning yourself, do not touch the cabinet.
• For details about fan activation, see page 16.
On placement
• Place the amplifier in a location with adequate
ventilation to prevent heat buildup and prolong the
life of the amplifier.
• Do not place the amplifier near heat sources, or in a
place subject to direct sunlight, excessive dust or
mechanical shock.
• Do not place anything on top of the cabinet that
might block the ventilation holes and cause
malfunctions.
• Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloraion of the
surface may result.
On operation
Before connecting other components, be sure to turn
off and unplug the amplifier.
On cleaning
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any question or problem concerning your
amplifier, please consult your nearest Sony dealer.
GB
24

Troubleshooting

If you experience any of the following
difficulties while using the amplifier, use this
troubleshooting guide to help you remedy the
problem. Also, see "Checking the connections"
on page 16 to verify that the connections are
correct. Should any problem persist, consult
your nearest Sony dealer.
There is no sound no matter which component
is selected.
• Check that both the amplifier and all components
are turned on.
• Check that the MASTER VOLUME control is
not set at "MIN".
• Check that all speaker cords are connected
correctly.
• Press MUTING to cancel the muting function.
There is no sound from a specific component.
• Check that the component is connected correctly
to the audio input jacks for that component.
• Check that the cord(s) used for the connection is
(are) fully inserted into the jacks on both the
amplifier and the component.
There is no sound from one of the front
speakers.
• Check that the component is connected correctly
to the audio input jacks for that component.
• Check that the cord(s) used for the connection is
(are) fully inserted into the jacks on both the
amplifier and the component.
The multi channel surround effect of the Dolby
Digital or DTS is not obtained.
• Check that the DVD software, etc. is recorded in
Dolby Digital or DTS.
• If you connect the DVD player, etc. to the digital
input jack on this system, check the audio setting
(for digital audio output) of the component.
• Check that the audio track is correctly selected
on the DVD player. (Check the audio setting of
the DVD menu.)