Sony HT-SL5A Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

x Surround speaker position
(
PL. XXX)*
SR
SL
This parameter lets you specify the location of
your surround speakers. Refer to the illustration
below.
• Select "SIDE" if the location of your surround
speakers corresponds to section A.
• Select "MID" if the location of your surround
speakers corresponds to section B.
• Select "BEHD." if the location of your
surround speakers corresponds to section C.
A
B
C
x Surround speaker height
(
HGT. XXX)*
SL
SR
This parameter lets you specify the height of
your surround speakers. Refer to the illustration
below.
• Select "LOW" if the location of your surround
speakers corresponds to section A.
• Select "HIGH" if the location of your surround
speakers corresponds to section B.
B
A
* These parameters are not available when
"Surround speaker size" is set to "NO".
90°
A
60°
30°
B
C
20°
B
60
A
30
Only when you use the speaker system
other than the supplied one, be sure to
set the following parameters.
The speaker size and sub woofer selection has been
preset to MICRO SP. (Micro Satellite Speaker)
according to the supplied speaker system. If you
change the speaker system, choose NORM. SP.
(Normal Speaker) to adjust the speaker size and sub
woofer selection. To select NORM. SP., turn off the
power, then turn on again while pressing the
MUTING button. (To reset to MICRO SP., do the
same procedure.)
Parameter
(FRONT)
L
R
(CENTER)
C
(SURR)
SL
SR
S.W. XXX (SUB WOOFER) YES
SW
You cannot change the configuration if you choose
MICRO SP.
x Front speaker size (
• If you connect large speakers that will
effectively reproduce bass frequencies, select
"LARGE".
• If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select "SMALL" to activate
the bass redirection circuitry and output the
front channel bass frequencies from the sub
woofer.
• When the front speakers are set to "SMALL",
the center and surround speakers are also
automatically set to "SMALL" (unless
previously set to "NO").
Initial setting
LARGE
LARGE
LARGE
)
L
R
continued
GB
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières