emerio CH-121946 Mode D'emploi page 7

CH-121946
PARTS DESCRIPTION
1. Air outlet
2. Air inlet
3. Handle (on both sides)
4. Power switch
5. Thermostat control switch
6. Turbo switch with indicator light
7. Feet
8. Power and thermostat indicator light
ASSEMBLY
Take the heater out of the packaging and turn it upside down.

Place the two feet onto the bottom of the unit. Fix them firmly by the two provided screws.

Turn the heater back and place it at an appropriate location.

OPERATION OF THE HEATER
Note: When the heater is turned on for the first time, or when they are turned on after a longer period of storage,
it is normal that the heater may emit some smell and fume. This will disappear when the heater has been on for
a short while.
Insert the plug into the power supply.

Turn on the power switch to choose the setting: I = 1000W, II = 2000W.

Turn the thermostat control switch in a clockwise direction to the MAX position.

Once the room temperature has reached the desired level, turn the thermostat control switch slowly in anti-

clockwise direction until you hear a "click" sound; this is the set temperature.
The appliance will automatically maintain the setting temperature. It will switch on when the room

temperature is below the setting (power and thermostat indicator light is on), and switch off if it is above
the setting (power and thermostat indicator light is off).
To turn off the heater, rotate the power switch back to "0".

After use, unplug the heater from the socket.

NOTE: this appliance is equipped with a turbo function. You can turn it on by pressing the turbo switch on the
side of the appliance to reinforce the air convection and speed up the rise of room temperature. To turn the
- 6 -
EN