P
REPARATION
BEFORE OPERATION
Setting the installation position
Be sure to set the slide switch inside the remote controller in accordance with
the installed position of the indoor unit.
Installation position:
Left:
Distance to objects (wall, cabinet, etc.) is less than 50 cm to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 50 cm to the left
and right
Right:
Distance to objects (wall, cabinet, etc.) is less than 50 cm to the right
(Left)
(Center)
(Right)
Area
Left
Slide switch
Remote controller
display
Press
during COOL mode to activate i-see control
operation.
• Press gently using a thin stick.
•
lights. (Operation display section)
Press
again to release i-see control operation.
i-see control operation
The sensors constantly measure the room and
fl oor/wall temperature to automatically adjust to
the set temperature by estimating the tempera-
ture actually perceived by a person inside the
room ("sensible temperature").
i-see sensor
When the AREA setting is not activated, the sensing range of the move eye sensor
differs depending on the installation location of the air conditioner.
Installation position
Left
Sensing range
Note:
Do not touch the i-see sensor. This may cause malfunction of the i-see sensor.
Slide switch
Center
Right
Room
Floor/wall
temperature
temperature
30.9%
43.7%
Humidity
20.7%
Center
Right
A
REA SETTING
Press
to select AREA. Each press changes
AREA in the following order:
(AUTO)
(Left)
• The i-see control operation has to be active to select AREA.
• Horizontal airflow direction
set.
*1 Horizontal airflow direction set by
Press
until "Cancel" is selected to release AREA
setting.
• Pressing
also releases AREA setting.
Area
(AUTO) ....The i-see sensor detects temperature disparities, efficiently
cooling the whole room.
In COOL mode:
Daytime
Warm area
(LEFT) /
(RIGHT)
Select the desired area to be air conditioned.
Indoor unit display
Horizontal airfl ow direction:
Left
Center or Swing
Cancel
(Right)
*1
cannot be selected when AREA is
.
Page 6
Nighttime
Cold area
Right
Lighted
Not ligted
En-4