Jimmy JV53 Mode D'emploi page 9

Cleaning Dust Cup and Filtration
System
Clean dust cup
Pull out downwards the dust cup On/ off button
to dump dust in dust cup.(Picture 16)
Press hard the dust cup release button, hold
steady the main body with right hand, rotate the
dust cup in the direction shown on the picture,
remove the dust cup from main body to further
clean the dust cup.(Picture17)
Clean filter system
Hold the main body, take the HEPA upwards as
shown in the picture, take out the HEPA, then take
out the dual-cyclonic system components, clean
them. (Picture18)
Fix inlet HEPA, rotate the HEPA cover in the
same direction as shown in the picture, separate
the HEPA cover from inlet HEPA, which will
be easily cleaned. After cleaning and drying,
assemble again.(Picture19&20)
Attention:The inlet HEPA must be fully dried before
installation.
Cleaning Electric Brushroll
1.Use your finger to release the brushroll button, take
out the side cover of the brushroll.
2.Take out one side of the brushroll in the same
direction as shown on the picture, then brushrollcan
be taken out to clean.
3.After cleaning and replacing, reassemble
it.(Picture21)
17
Dust Cup
Release
18
HEPA Filter
Dual-cyclonic
System
Components
19
HEPA
Cover
Inlet HEPA
21-1
Brushroll
Release Button
①
Brushroll Cover
②
20
21-2
7