Epson EB-1410Wi Guide D'installation page 25

h
Secure the projector to the setting plate
(1) Loosen the two screws and remove the cable cover from the projector.
Screws (x2)
(2) Insert the slide plate into the setting plate from the interface side of the projector (
Align the 3-axis adjustment unit with the slide plate's standard position (
(3) Tighten the M4 x 12 mm hexagon socket head cap bolts (x2) (
Slide plate
Projector interface
side
Spring washer
M4 x 12 mm hexagon socket head cap bolts
Warning
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils
on the slide plate fixing part of the projector, the case may crack and cause the projector to fall,
resulting in personal injury or property damage. Do not use adhesives, lubricants, or oils to
install or adjust the setting plate.
Washer
Standard position
25
Cable cover
).
).
Bolt positions
).