Calculated Industries 6020 Guide De L'utilisateur page 4

[MODE] – Mode Selection
Used to toggle between the following scale
modes (in sequence):
1) Architectural (
2) Engineering I (
3) Engineering II (
4) Custom (
5) Count (
[SUBTRACT/COUNT]+[MODE] –
Unit Selection
Holding
repeated presses of
through the available units. Values can be
converted from U.S. units to Metric within
the U.S. mode. However, values cannot
be converted from Metric to U.S. when in
Metric mode.
[SCALE] – Scale Selection
Used to toggle between various scales within
each scale mode. See "Built-In Scales" section.
[M1+] – Memory Add Key (Length)
Adds the displayed value to the M1+
memory. This key is used to store a length in
order to calculate an area.
[M2x] – Memory Add Key (Width)
Adds the displayed value to the M2x memory.
This key is used to store a width in order to
calculate an area. When a length and width have
been stored in
[RCL] [M2x]
next press of
from the stored length and width, and the next
press of
a height has been stored. Please see page 12 for
calculating an Area and Volume.
2 – Scale Master
CUSTOM
COUNT
[SUBTRACT/COUNT]
[M1+]
displays the stored width, the
[M2x]
[M2x]
displays the calculated volume if
Classic
®
ARCH
)
ENG I
)
ENG II
)
)
)
[MODE]
will scroll
[M2x]
and
displays the area calculated
and
, pressing