Setting A Height - Calculated Industries 6020 Guide De L'utilisateur

6) Press:
[M1+]
[SUBTRACT/COUNT]
[SCALE]
[MODE]
7) Continue to press
are set and display returns to zero. The scale
is now stored.
[RCL] [SCALE]
Press
display the current custom scale.

Setting a Height

The height function is used to enter a height
value for finding volume.
[SUBTRACT/COUNT]
1) Press
annunciator will begin flashing "
U.S. mode or "
2) If you do not want to change the units, go
to step 3. To change the units, press
until you reach the desired unit.
[SCALE]
3) Press
The left-most digit will begin flashing.
Press:
[M1+]
[SUBTRACT/COUNT]
[SCALE]
[MODE]
4) Continue pressing
are set and the display returns to zero. The
height is now stored.
Note: Once you set your height, you do not need to
enter it again unless you want to change it.
to increment the selected digit,
to advance to next digit,
to move back one digit,
while in custom mode to
" for Metric mode.
M
to begin setting the digits.
to increment the selected digit,
to advance to next digit,
to move back one digit.
to decrement,
[SCALE]
until all digits
to decrement,
[SCALE]
until all digits
[M2x]
+ . The
" for
FT IN
[M1+]
11 – User's Guide