Calculated Industries 6020 Guide De L'utilisateur page 12

(Cont'd)
flashing "
Metric Mode.
5) If you do not want to change the units,
skip to step 6. If you want to change the
units, press
desired units.
[SCALE]
6) Press
The left-most digit will begin flashing.
Press:
[M1+]
[SUBTRACT/COUNT]
[SCALE]
[MODE]
7) Continue to press
are set and the display returns to zero. The
scale is now stored.
Entering a Custom Scale
[MODE]
1) Press
number 1-3) appears in the scale box display.
[SUBTRACT/COUNT]
2) Press
" " will appear in the main display.
ROLL
[SCALE]
3) Press
begin flashing "
left-most digit flashes for Metric Mode.
Note: If in Metric Mode, skip to Step 5.
4) If you want to change the units, press
[M1+]
Then press the
setting the distance. The left-most digit
will begin flashing.
5) In U.S. mode, the scale will be one inch
equals the distance you entered. In Metric
mode, entered scales are direct ratios.
10 – Scale Master
" for U.S. Mode or "
FT IN
[M1+]
to begin setting the scale distance.
to increment the selected digit,
to advance to the next digit,
to move back one digit.
until
again. The annunciator will
FT IN
until you reach the desired unit.
[SCALE]
Classic
®
until you reach the
to decrement,
[SCALE]
until all digits
#
(# being a
OPEN
" for U.S. Mode. The
key to begin
" for
M
[SCALE]
+ .