Yamaha HY128-MD Mode D'emploi page 2

Responsible Party: Yamaha Corporation of America
Type of Equipment: Audio Interface Card
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired
operation.
* This applies only to products distributed by Yamaha Corporation of America.
1. IMPORTANT NOTICE: DO NOT MODIFY
THIS UNIT!
This product when installed as indicated in the
instructions contained in this manual, meets
FCC requirements. Modifications not expressly
approved by Yamaha may void your authority,
granted by the FCC, to use the product.
2. IMPORTANT:
to accessories and/or another product use only
high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all
installation instructions. Failure to follow
instructions could void your FCC authorization
to use this product in the USA.
3. NOTE:
This product has been tested and
found to comply with the requirements listed in
FCC Regulations, Part 15 for Class "B" digital
devices. Compliance with these requirements
provides a reasonable level of assurance that
your use of this product in a residential environ-
ment will not result in harmful interference with
other electronic devices. This equipment gen-
erates/uses radio frequencies and, if not
installed and used according to the instructions
found in the users manual, may cause interfer-
ence harmful to the operation of other elec-
tronic devices. Compliance with FCC
CAN ICES-3 (B)/NMB-3(B)
2
HY128-MD Owner's Manual
COMPLIANCE INFORMATION STATEMENT
(Supplierʼs declaration of conformity procedure)
Address: 6600 Orangethorpe Ave., Buena Park, Calif. 90620
Telephone: 714-522-9011
Model Name: HY128-MD
FCC INFORMATION (U.S.A.)
When connecting this product
(can_b_02)
regulations does not guarantee that interfer-
ence will not occur in all installations. If this
product is found to be the source of interfer-
ence, which can be determined by turning the
unit "OFF" and "ON" please try to eliminate the
problem by using one of the following mea-
sures:
- Relocate either this product or the device
that is being affected by the interference.
- Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits or
install AC line filter/s.
- In the case of radio or TV interference relo-
cate/reorient the antenna. If the antenna
lead-in is 300 ohm ribbon lead, change the
lead-in to co-axial type cable.
If these corrective measures do not produce
satisfactory results, please contact the local
retailer authorized to distribute this type of
product. If you cannot locate the appropriate
retailer, please contact Yamaha Corporation of
America, Electronic Service Division, 6600
Orangethorpe Ave. Buena Park CA 90620,
USA
The above statements apply ONLY to those
products distributed by Yamaha Corporation of
America or its subsidiaries.
(FCC SDoc)
(class B)