Kenmore 110.6163 610 Série Guide D'utilisation Et D'entretien page 15

If you experience
Dryer Results (cont.)
Load too hot
Dryer Displaying Code Message or Indicator Is Lit
"L2" Diagnostic Code
(low or no line voltage
condition)
"Check Vent" cycle
status indicator lights
up (blocked vent or low
etc.) variable service
codes
TROUBLESHOOTING
Possible Causes
Load removed before cool down
portion of cycle complete.
Using Timed Dry cycle with a high
temperature setting.
The drying cycle has been interrupted
by a power failure.
There may be a problem with your
home power supply, keeping the
dryer's heater from turning on.
The lint screen or vent is clogged.
The vent is crushed, kinked or has
too many turns.
The dryer is in need of service.
Allow the dryer to complete the cool-down portion of the cycle
before removing the load.
Select a Sensing Cycle with a lower heat setting to avoid
overdrying the load.
START to resume cycle.
The dryer will continue to run when this diagnostic code is present.
Touch any pad to clear the code from the display and return to
the estimated time remaining.
Try the following:
• Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use 2 household fuses or breakers.
Replace the fuse or reset the circuit breaker.
•
the Installation Instructions for details.
• Select a Timed Dry heated cycle, and restart the dryer.
The dryer will continue to run when this diagnostic code is present.
Touch any key to clear the code from the display and return to
the estimated time remaining.
Try the following:
• Clean lint screen.
• Check to see if the vent run from the dryer to the wall is
crushed or kinked.
•
of lint and debris.
•
and debris.
•
run length and number of elbows for the type of vent you are
using. Refer to "Plan Vent System" in the Installation Instructions
for details.
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, have your entire home venting run
cleaned. Contact a venting specialist.
that requires service. Call for service.
Solution
15