Cembre B1300PL Notice D'utilisation Et Entretien page 6

WARNINGS
Hydraulic pumps manufactured by Cembre S.p.A. are developed for use with crimping or cutting
heads. According to this specifi c use, they do not need and are not equipped with an oil non-return
safety system.
For this reason, use in applications diff erent from those intended (for example with hydraulic jacks,
lifting systems or similar) can be dangerous for the operator.
Cembre S.p.A. does not accept any liability arising from the use of its hydraulics pumps for ap-
plications diff erent from those listed in its catalogues or other documentation.
Do not use the pump for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain a bal-
anced working position.
Do not build up pressure if the pump is not connected to the fl exible hose and the head as this may
damage the pump quick coupler, precipitating oil seepage.
High pressure flexible hoses are subject to a natural ageing process which can result in a reduction
in performance potentially affecting safety of the operator. As a result their life span is limited.
In order to ensure safe use of their units, Cembre recommends replacing the hose within 10
years from the date printed on the fittings.
Keep the pump and fl exible hose away from naked fl ames and sources of heat above 70°C.
Before using the pump always check the integrity of the fl exible hose and the quick couplers making
sure there are no abrasions, cuts, deformations or swellings.
The factory fi tted guards must be in place at each end of the fl exible hose.
Do not touch the fl exible hose when under pressure.
When using the pump, the fl exible hose must be uncoiled and laid out straight.
Before disconnecting the fl exible hose, check that the ram of the head is completely retracted, ensure
a suffi cient quantity of oil for subsequent operations.
The pump is unsuitable for continuous use and should be allowed to cool down following uninter-
rupted, successive crimping operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the pump from rain and moisture. Water will damage the pump and battery.
Electro-hydraulic tools should not be operated in pouring rain.
6