Thermostat Instructions - Warm Tech WTCHMO2003TL-WI Instructions D'origine

1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on a firm level surface ,setting the master button to "-"position.plug the
cord set into a AC220-240V electrical outlet,with "BEE" sounds the "Power"light is on and the
heater will shows the room temperature.
1.Set time
WEEK Press "Set" button again,"Mo"light twinkle ,press "
Mo--Su (Mo=Monday...Su=Sunday ect.)
HOUR Press "Set" button one time,LED display front "00" twinkle, press"
the Hours from 01--00(01=1 o'clock,02=2 o'clock...00=24 o'clock ect.)
MINUTE Press "Set" button again,LED display behind "00" twinkle, press "
set the minutes from 00--59(01=1 Minute,02=2 Minute ect.)
2)General Using OPERATION
1. Turn the heater ON by pressing remote control the ON/OFF button ,the unit will blow the
cold air .
2. Pressing the "MODE" button on remote control ,the unit will blow the warm air and
will light on.
3. Pressing the "MODE" button second times on remote control,the unit will blow the hot air and
the will light on
4.Pressing the "MODE" button Three times on remote control,the unit will blow the cold air
5. Pressing the "Swing" button,the heater will be
PS:For smart operate,customer only press the one start button near about master
button,the heater will working with hot air and Swing function.
4) 24H Timer FUNCTION
1. Press " " button ,set the timer up to 24 hours,keep press "
from 00--24(00=close,01=1hour,02=2 hours...24=24 hours ect.) and the "
PS:set as "00" means no set timer ,the "

5) THERMOSTAT INSTRUCTIONS

1. To adjust temperature,press the "
set from 10℃ to 49℃
2. When the air temperature drops 2 degree below the set temperature,the heater will start
heating with "I/W"(1000W).
3. When the air temperature drops 4 degree below the set temperature ,the heater will start
heating with"II/H"(2000W).
4. When the air temperature high 1 degree or ≤ the set temperature,the heater will blow the cold
air .
6) WINDOW OPEN FUNVTION
swing the blade up and down
" light is off.
" to set the desired temperature and the temperature
two buttons set the week from
two buttons set
two buttons
" button to increase the hours
" light is on.
29