EdilKamin DOUBLE Installation, Usage Et Maintenance page 13

The structure is constituted by a high quality steel sheet body, hermetically welded, equipped with adjustable feet, completed with ECOKERAM
hearth and basin fire surface, for a correct control of the ash.
The structure is completed by a shell which realises an air space for the circulation of the heating air.
The air for the heating circulates naturally and can be channelled to near by rooms.
3
B
16
17
5
7
9
18
THE TECHNOLOGY
1
2
4
B
15
6
5
8
A
fig. 1
18
13
12
10
fig. 2
11
Particular care has been taken in the inlet of the fuel air in the hearth
to guarantee optimum fuelling, a calm flame and a very clean
glass.
The fuelling primary air
A
surface on the open coal.
The amount of the primary air is adjustable depending on the
draught of the flue through a mobile deflector installed at the front of
the hearth (fig.3).
For a flue with a weak draught, it is possible to increase the inlet
section of the primary air and vice versa, decrease it in case of
excessive draught.
The fuelling secondary air
enters at the glass peak after having been heated.
The amount of secondary and glass cleaning air is pre-calibrated.
14
fig. 3
LEGEND: (fig. 1 - 2 - 3)
1. smoke outlet fitting
2. coolingfoil
to improve the heat exchange
3. smoke switch conduit
to improve the heat exchange
4. steel structure
5. air power supply conduit
to keep the glass clean
6. hearth inside in very thick ecokeram
to increase the fuelling temperature
7. ceramic glass
resistant to heat shock of 800° C
8. hatch removable handle
to lift/lower the hatch
9. basin fire surface
to accumulate coal and obtain optimum fuelling
10. external air inlet grill
11. adjustable feet
12. shell for circulating heating air
13. heating air inlet, internal air circulation
14. mobile deflector
15. sliding hatch
16. door
17. door removable handle
for opening door
18. 14 cm flexible aluminium pipe to duct air for
heating (optional)
(fig 1) enters at the base of the fire
(fig 1) and glass cleaning air
B
13