Initial Use - Princess 232613 Mode D'emploi

If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
Description (fig. A & B)
Your 232613/232614 Princess water boiler has
been designed for boiling water. The appliance
has a removable filter in the spout (fig. B).
The appliance is not suitable for boiling liquids
other than water. The appliance is suitable for
domestic use only.
1. On/off switch
2. On/off indicator
3. Water boiler
4. Water level indicator
5. Lid
6. Lid release button
7. Handgrip
8. Base
9. Removable filter

Initial use

Preparation (fig. A & B)
• Clean the appliance. Refer to the section
"Cleaning and maintenance".
Warning!
- Before first use, completely fill the water
boiler with water without using the water for
consumption or other purposes.
• Fill the water boiler (3) with water up to the
maximum mark on the water level indicator
(4).
• Boil the water.
Refer to the section "Boiling water".
• Empty the water boiler (3).
Use
Boiling water (fig. A & B)
Warning!
- Before filling the water boiler, always
remove the water boiler from the base.
- Only use tap water to fill the water boiler.
- Always make sure that the water level is
between the minimum mark and the
maximum mark on the water level indicator
(fig. A). If the water level is below the
minimum mark, the water boiler will boil dry.
If the water level is above the maximum
mark, the water boiler will boil over and hot
water will spray out.
- Do not remove the water boiler from the base
until the appliance has been switched off.
• Place the appliance on a stable and flat
surface.
• Remove the water boiler (3) from the base
(7).
• Open the lid (5) by pressing the lid release
button (6).
• Fill the water boiler (3) with water.
• Place the water boiler (3) onto the base (7).
• Insert the mains plug into the wall socket.
• To switch on the appliance, press the on/off
switch (1). The on/off indicator (2) comes on.
The appliance starts to boil the water.
• To interrupt the process, remove the mains
plug from the wall socket.
• If the process is completed, the appliance
switches off automatically. The on/off
indicator (2) goes off.
Cleaning and maintenance
Warning!
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
other liquids.
Caution!
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
10