Maintenance - Greencut JET220C-4 Manuel D'utilisation

PRESSURE
1. The nozzle controls the pressure of the machine. Push the nozzle to
the closed position to operate the machine in high pressure mode and
keep at least 30 cm away from the workpieces.
2. To operate the machine in low pressure mode, pull out the nozzle. In
this position you can feed detergent into the tank.
ATTENTION: Detergent will not be dispensed in high pressure
mode.
ATTENTION: It is necessary to dilute the detergent for more
effective cleaning. It is recommended to dilute the detergent
in a suitable container to a ratio of 1%.
DISCONNECTION OF EQUIPMENT
1. Turn off the water supply to the tap.
2. Press the trigger to reduce the pressure in the appliance.
3. Pull out the water inlet hose and let the appliance run for a few
seconds to allow the water to be stored in the pump.
4. Turn off the appliance and disconnect the electrical plug from the
socket.
5. Disconnect the pressure hose. To drain the waste water, lift the jet gun
and press the trigger.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
For safety, clean the appliance every three months. Before putting the appliance into operation, check the filter and
nozzle for impurities. After the cleaning operation is complete, make sure that there is no water left in the pump and
hose.
43
EN
Detergent
tank
ON
OFF