Maintenance - Greencut JET200L Manuel D'utilisation

POWER ON
On first use, it is necessary to empty the air from the hose, position the power nozzle below waist level (<5 ft/1.5 m),
then connect the extension lance and set it to high pressure. waist level (<5 ft/1.5 m), then connect the extension
lance and set it to high pressure.
Do not start work until water comes up the hose and sprays out.
This may take up to 30 seconds or more, depending on the fresh water source.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
For safety, clean the appliance every three months. Before putting the appliance into operation, check the filter and
nozzle for impurities. After the cleaning operation is complete, make sure that there is no water left in the pump and
hose.
51
EN