LEGRAND 672 81 Manuel D'utilisation page 23

Scenario setup
To program a scenario, touch the icon the scenario must be associated
to for three seconds. An audible signal notifies the start of the learning
procedure and the display shows the name and icon of the selected
scenario. The learning page is displayed:
NIGHT
Scenario
name
"Learning
beingcompleted"
bar
You can now create a scenario using the automation, temperature
control, sound system functions etc. of the system. Simply touch the
display to confirm. The device will return to the Home page.
It is important that the scenario module (035 51) of the system is
correctly enabled for programming.
If the device does not receive any command within 30 seconds from
the start of the learning procedure, programming will automatically be
interrupted, and the screen will return to the Home page.
Cancel scenario
To cancel a scenario, touch the corresponding icon for 10 seconds.
An acoustic signal will be heard, and the screen will display a screen
confirming that the scenario has been cancelled.
Message
S ce n a r i o
icon
Local Display will return to the Home page
In the following page, your installer will fill the table of the scenarios
associated to your Local Display.
23
ERASE
2 - Use